?

Log in

No account? Create an account

Josh-D. S. Davis

Xaminmo / Omnimax / Max Omni / Mad Scientist / Midnight Shadow / Radiation Master

Previous Entry Share Next Entry
Tools and Shimano Gripe
Josh 201604 KWP
joshdavis
My replacement, smaller torque wrench came in. It works. I can throw away my super-long one that does not work. I have a non-ratcheting breaker bar I'll keep instead and not be tempted to see if it works.

I installed a Selle Respiro Moderate Men's saddle to test out on my 50-60 mile ride tomorrow. I hope it's not a big mistake. Maybe I should bring my old seat with me. It *seems* more comfy, but it also seems set-back too far. May need to pull it all the way forward, AND tilt it down 1-2 degrees.

Two of my bikes use Shimano bottom brackets. I found that the Shimano BB-UN55 (Bottom Bracket - crank spindle with sealed bearings) has different splines on each side. Standard, flat-bottom splines all the way into the cup on the non-drive side. All tools work okay on this. The drive side is cut into stainless steel, is tapered, and only half-way into the cup. The Park tool for this really doesn't work. The Avenir tool is pretty decent, and got me fixed up, but it was still a pain. I have Pedro's tool on order, which has tapered splines, and should work even better.

What would be best is if Shimano cut the spline grooves all the way down to the BB shell. Though, maybe I can take the Park tool and file the splines.

Note to self: 450-600 inch pounds for the BB shell, and 300-400 inch pounds for the crank bolt. Everything else is labelled with torque specs visible during install, but the BB specs are inside the frame during install.
http://omnitech.net/xaminmo/2014/02/14/tools-and-shimano-gripe/